【The Stand For Hanging Doll】Ready for sale!

SEDOLL Brand was established in 2016
We offer different sex doll models for different purposes and we follow the needs of customers.
Forum rules
Image
Post Reply
SEdoll
Posts: 154
Joined: Thu Nov 19, 2020 6:36 am

【The Stand For Hanging Doll】Ready for sale!

Post by SEdoll »


1. Basic description

The hanging stand is one of the most convenient tools to store doll products.
Storage by hanging the dolls can avoid skin material damage caused by long
-time extrusion and effectively save space.

SEDoll's hanging stand includes three components: (1) the lower part
with casters for movement, (2) the middle part for fixing and connecting,
and (3) the upper part for connecting hooks.

The length of the lower part can be adjusted according to the weight
of the doll (adjustable up to 15cm); the length of the upper part can
be adjusted by the height of the doll (between 100cm to 190cm). The
maximum load capacity of the hanging stand is 80kg.

Image


2. Installation Instructions

a. Bottom stand (video position: 00:09)
(including 4 pieces in total: 2 iron rods (long) & 2 iron rods (short) )

Image

Install two casters (use one caster with a locking switch and one without)
on one end of the two shorter iron rods.

Image

The long iron rod comes with adjustable features, consists of two sections
(connected by two white screws). To adapt and balance the weight of the
doll, the long iron rods can be adjusted into different lengths (adjustable
up to 15cm).

For the lighter doll, the adjustable rods should be shortened, and for the
heavier doll, the adjustable rods should be extended to adapt to the weight.
After adjusting and tightening the screws, install the two casters to the long
iron rods (use one caster with a locking switch and one without).

Image

Image

After assembling the four iron rods, buckle them into the centerpiece,
and install them into the four holes, fasten with silver screws.

Image

Image


As shown in the figure after installation:

Image


b. The middle of the stand (video position 03:45)

The handle of the middle part (metal column) must be facing the same
side as the shorter iron rods of the bottom stand. Align the four holes of
the middle part with the four holes of the bottom stand, and fasten them
with blue screws.

Image

Image


c. The upper part of the stand (video position 04:02)

The hook must be facing the same side as the long iron rods of the
bottom stand (as shown in the figure below). The upper part can be
adjusted to suit the height of the doll (range between 100cm to 190cm).
After confirming the height, fasten the screws and tighten the handle
to finish the stand.

Image


3. Activities and other instructions

Rolling method: After hanging the doll, the best way of rolling is to
move backward with both hands under the weight limit. Pushing
forward is not recommended. CAUTION: The stand rod may break
due to the excessive weight of the doll and the excessive force.
(Video position: 05:42)

Load Capacity: It is normal for the pole to bend slightly after the doll
is hung on the stand. The maximum load capacity of the stand is 80kg.

Locking Casters: After determining where the doll is parked, you can
twist the switch on the side of the casters to stop the roll. The locking
switch is located on the sides of the two wheels on the opposite corner.
When the locking mechanisms are applied, the stand will be locked into
place and cannot be moved. (Video position 05:48)

Image

Image


The final effect is shown in the figure:

Image

(Check out more pics of this silicone body in picture: http://d.v4t.cn/SueCW)

Besides, please ask any other questions in the reply zone!


Post Reply